Cast saw

Saw for removing orthopedic casts

2 min read

Why this is trending

Interest in “Cast saw” spiked on Wikipedia on 2026-02-25.

When a Wikipedia article trends this sharply, it usually reflects a noteworthy real-world event—whether breaking news, a cultural milestone, or a viral discussion driving collective curiosity.

By monitoring millions of daily Wikipedia page views, GlyphSignal helps you spot cultural moments as they happen and understand the stories behind the numbers.

2026-01-27Peak: 602026-02-25

30-day total: 1,178

Key Takeaways

A cast saw is an oscillating saw used to remove orthopedic casts.
This device is often used with a cast spreader.
The design enables the saw to cut rigid materials such as plaster or fiberglass.
Modern cast saws date back to the plaster cast cutting saw which was submitted for a patent on April 2, 1945, by Homer H.
Cast removal procedures result in complications in fewer than 1% of patients.

A cast saw is an oscillating saw used to remove orthopedic casts. Instead of a rotating blade, cast saws use a sharp, small-toothed blade rapidly oscillating or vibrating back and forth over a minimal angle to cut material and are therefore not circular saws. This device is often used with a cast spreader.

The patient's skin frequently comes into contact with the cast saw blade without cutting although it can cause lacerations when used over bony prominences. The design enables the saw to cut rigid materials such as plaster or fiberglass. In contrast, soft tissues such as skin move back and forth with the blade, dissipating the shear forces, and preventing injury.

Modern cast saws date back to the plaster cast cutting saw which was submitted for a patent on April 2, 1945, by Homer H. Stryker, an orthopedic surgeon from Kalamazoo, Michigan.

Cast removal procedures result in complications in fewer than 1% of patients. These complications include skin abrasions or thermal injuries from friction between the saw and cast. Temperatures exceeding 101 °C (214 °F) have been recorded during the removal of fiberglass casts. The proper use of the saw is to perforate (instead of cutting) the cast, which can then be separated using a cast spreader.

Alternatives include cast cutting shears which were patented in 1950 by Neil McKay.